Audionet AMP VII, Руководство пользователя, Страница: 11 / 27

11
if the mains plug to mains input
mains2
25 has the wrong orienta-
tion. In this case please switch off the unit with the
power
key to
stand-by mode. Then disconnect it from mains with the mains switch
on the bottom side. Now, flip the mains plug with the wrong orienta-
tion in the wall outlet (see section '
Mains phase detection ' on page
14).
5 Inputs and outputs
Important
·
For connecting or removing loudspeakers and/or the pre ampli-
fier your AMP VII must be switched off to prevent damage to the
amplifier or the connected units.
·
Please make sure that all cables are in absolute best conditions!
Broken shields or short-cut loudspeaker cables could damage
speakers and/or amplifiers.
5.1 Inputs
At first, connect your pre amplifier to inputs 1 to 14 (depending on the
number of modules) of your AMP VII. For each channel (module) you
may choose to use Cinch or balanced (XLR) cables alternatively. For
cable lengths exceeding 10 m we recommend the use of balanced cables.
Important
·
Do not forget to select the inputs you are using in the setup menu (see
section '
Set Input ' on page 21).
·
The input may be selected for each channel individually.
5.2 Speaker terminals
Now connect your speakers to the gold plated terminals 15 bis 21 on
the back panel of the AMP VII. You can use both banana plugs or spades
as well as simple cable ends.