Audio Technica ATND1061DAN, Руководство пользователя

Страница: 75 / 88

Troubleshooting
74
No sound emitted from analog output
Check whether the analog I/O ports on the back of the microphone are connected correctly.
Check whether the pin assignments for the analog I/O ports on the back of the microphone are correct.
Strange noises are emitted
Check whether the target zone is set to the effective range in the beam settings of Digital Microphone
Manager.
Check whether the 4-band EQ settings of Digital Microphone Manager are correct.
Check whether the position and orientation of the microphone are correct for the room.
Indicator lamp does not light
Check Digital Microphone Manager to see whether “LED Dimmer” is set to “ON”.
AEC does not function
Check Digital Microphone Manager and Web Remote to see whether settings for “AEC” > “AEC Reference”
are correct.
Check whether far end audio is routed to “AEC Ref In” of the microphone’s Dante receiver using Dante audio
routing.
Preset settings do not sync between multiple microphones
Check Digital Microphone Manager to see whether “General” > “Command Link” > “Preset Link” is set to
“ON” for all microphones.
IR remote controller does not operate
Check whether the battery is installed in the correct orientation.
Check whether the battery is dead. Replace the battery if dead.
Check Digital Microphone Manager to see whether “IR Receiver” > “Allow Control” is set to “ON”.
IP control is not possible
Check whether the microphone and computer are connected to the same network.
Check whether the port No. used for IP control is correct.