Audio Technica ATND1061DAN, Руководство пользователя

Страница: 74 / 88

73
Troubleshooting
Please check the following when problems with the microphone occur. Also see the user manual -Digital Microphone
Manager Edition-.
Check whether the microphone is connected correctly.
Check whether the microphone is operating as described in the user manual.
Check whether external devices are operating correctly. Perform this check with the microphone disconnected.
Restart network devices.
Microphone doesn’t turn on
Check whether the port for Network A on the back of the microphone is connected to the PoE switching hub
using a LAN cable of CAT5e or higher.
Check whether the PoE switching hub is operating correctly.
Microphone is not recognized by Digital Microphone Manager or Web
Remote
Check whether the microphone and computer are connected to the same network.
Review firewall settings.
Check Digital Microphone Manager and Web Remote to see whether “Allow Discovery” > “Enabled” is set
to “ON”.
Microphone is not recognized by Dante Controller
Check Digital Microphone Manager to see whether settings for “Dante Network Configuration” > “Mode”
are correct.
Check whether the Dante audio connected to the port for Network A on the back of the microphone is
connected to the same network as the connected Dante device.
No sound emitted from microphone
Check whether the beam output (Dante transmitter) is correctly routed to the Dante receiver of the output
device using Dante Controller.
Check Digital Microphone Manager to see whether the Exclusion Zone has been set.
Check whether the audio I/O level is set to “-∞” (minimum value) in the audio settings of Digital Microphone
Manager.
Check whether any beam channels are muted.
If using an Auto Mix channel for output, check whether the auto mix settings for each beam channel in
Digital Microphone Manager are correct.