Audio Authority SF-16M, Руководство по установке

Страница: 21 / 36

21
System Setup
From this menu you can check the status of the system, adjust front panel settings,
network status, Update Firmware name sources and Zones, reboot, and reset to
factory default. It is often convenient to turn DHCP on to connect automatically to a
DHCP network for initial setup. Once the SF-16M is installed, use a static IP address
and turn DHCP off.
Front Panel
Brightness - Brightness level of the keys and front panel display. Choose 100%,
75%, 50%, or 25%. Also accessible by the dim button on the keyboard.
Front Panel IR On/Off - Disable / enable front panel IR sensor. If not required for
control, leave it off to avoid issues with sunlight or other interference.
Display Lock - Disable / enable the front panel controls.
Sleep Timer - Turns off the front panel display after the front panel keys and knob
have not been used for a period of time. Select a time period of 0, 1, 2, or 5
minutes. Select (zero) if the display should remain on. The display is turned off
automatically when entering standby unless the sleep timer is set to zero.
Network
This screen displays the status of the network, the native IP address, gateway,
subnet mask, and mac address ( Figure 49 ). It is often convenient to turn DHCP on
to connect automatically to a DHCP network for initial setup. Once the SF-16M is
installed, use a static IP address and turn DHCP off. If the network settings have
changed but not yet committed, this screen displays a message.
Import File
Import or restore configuration settings from USB drive ( Figure 50 ).
Export File
Export configuration settings for archiving onto USB drive.
Firmware
This screen displays the unit number, the system firmware and bootloader, and the
input board firmware and bootloader versions. To update firmware load the new
version onto a USB drive, insert the drive into the USB port, and select
update firmware.
Zone and Source Naming
When creating or editing source or Zone names, the menu key also toggles the
cursor display between numeric, uppercase, lowercase and blank space. The Dim
and Back keys move the cursor left and right respectively ( Figure 51 ).
Reboot
Allows power cycling of unit when required (firmware updates etc.).
Factory Reset
If you need to clear all the settings in the SF-16M and return it to default values, use
the Factory Reset command ( Figure 53 ). The only way to restore custom settings is if
you have an archive saved on a USB drive or computer hard disk.
Figure 45.
Figure 46.
Figure 47.
Figure 48.
Figure 49.
Figure 50.
Figure 51.
Figure 52.
Figure 53.