Audio Authority Access EZ 922, Руководство по установке системы

Страница: 24 / 52

24
Switch Settings
Switch Function Comments
A Keyboard Click Turn ON for audible key feedback or “beep”
B Demo-Mode Leave OFF. Use only when control panel is not
connected to a system as a “Training Mode”
C Systems ON makes the last (unused) Product Group capable of
Memory storing and recalling 99 system configurations ( see 903 manual )
D Future Use Spare, leave OFF
E Previous Selection OFF = “C” key is third “flash memory” key
ON = “C” key is toggle between current selection and previous selection
F 903 Turn ON
G Internal IR Turn OFF when using Remote IR Receiver
H Auxiliary IR Turn ON when using Remote IR Receiver
906G / 906G Primary/Secondary This switch should only be in 906GA mode when two 906G modules are
controlling the same product group.
Group Address Set this switch to the number of the Product Group it will control.
Spk / Elex Speakers or Electronics Set to Spk for controlling speaker groups, and Elex for controlling
soundbars, AVRs, or source devices.
D. Mount the control panel using the four screws provided. Do not overtighten the screws.
906G
903
Figure 39. PSB header locations on 942 module.
PSB headers
2. Installing Product Select Buttons
You may use product select buttons (PSBs) alone, or in conjunction
with a control panel.
A. Determine where each PSB will be located, usually close to the
product the PSB will select, and often near product
information tags.
• For plastic Model 999 PSBs: drill a 1
1
⁄
8
” hole in the
panel or surface. Remove the nut and feed the switch
through the hole. Tighten the nut and install the white
switch mechanism.
• For stainless steel 803-190 or PSB-224: Drill a
3
⁄
4
"
(19 mm) hole. Maximum panel thickness is
1
⁄
2
”
(12.5 mm). Required depth is 2” behind front panel
surface. Tighten the nut.
B. You may wish to leave the PSB mounted in the product panel,
or install them later, after your components have been mounted.
TECH TIPS