Audi TT Coupe 2014, Руководство пользователя

Страница: 247 / 284

0
N
co
,-j
\D
L/'l
N
L/'l
,-j
� Note
Note the code number of the anti-theft wheel
bolt and keep it in a safe place - not in your
vehicle. If you need a replacement adapter,
give the code number to your Audi dealer.
Loosening the wheel bolts
Fig. 230
Changing a wheel: Loosening the wheel bolts
.,. Fit the box spanner (provided in the vehicle's
tool kit) as far as it will go over the wheel
bolt
1 >.
.,. Turn the wheel bolt approx. one turn anti-clock­
wise -arrow-. To apply the necessary torque,
hold the box spanner near the end. If the wheel
bolt is very tight, you may be able to loosen it
by pushing down the end of the spanner care­
fully with your foot. Hold on to the car for sup­
port and take care not to slip.
.&_
WARNING
To avoid accidents, the wheel bolts should on­
ly be loosened slightly (one turn) before rais­
ing the vehicle with the jack*.
ll An adapter is required to unscrew or tighten the anti-theft
wheel bolts � page
244.
Mobility
Raising the vehicle
Fig. 231
Sills: markings (example)
Fig. 232
Door sill: Applying the jack under the door sill
.,. Always provide a firm base for the jack* on the
ground. (The jack can be found in the vehicle's
tool kit). If necessary use a large, strong board
or similar support. On a hard, slippery surface
(such as tiles) use a rubber mat or similar to
prevent the jack from slipping ¢
,,& .
.,. Locate the marking on the door sill closest to
the wheel being changed¢
Fig. 231.
The jack­
ing point is located behind the marking under
the door sill.
.,. Wind up the jack* under the jacking point until
the claw @ ¢
Fig. 232
of the jack is directly be­
low the jacking point .
.,. Align the jack* so that the claw @ grips the
jacking point under the door sill and the mova­
ble base plate of the jack @ is flat on the
ground. The base plate @ must be positioned
vertically underneath the jacking point @ .
.,. Raise the vehicle until the defective wheel is
clear of the ground.
.,.
245