0
N
co
....
\D
Lfl
N
Lfl
....
lamp
[Bl
and a message on the infotainment dis
play. If only one tyre is affected, the display will
indicate its position.
Each time you change a tyre, change the wheels
round or change the tyre pressures on your vehi
cle (e.g. when switching from partial load to full
load and vice-versa), you must store the new tyre
pressures on the infotainment system
¢
page 235.
Monitoring of the tyre pressures is
based on the tyre pressures you have stored. The
inflation pressures recommended for your vehicle
are given on the tyre pressure sticker
¢
page 233, Fig. 220.
The rolling circumference and vibration can
change and cause a tyre pressure warning if:
- The inflation pressure in one or more tyres is
too low.
- The tyre has suffered structural damage.
- The wheels were changed or the tyre pressures
were changed and the new tyre pressures were
not stored¢
page 235.
- You are driving with the temporary spare
wheel*.
Indicator lamps
RI]-
Loss of pressure on one or more tyres¢
A
.
Check and change or repair the tyre(s). Check and
adjust the inflation pressures of all four tyres
again and store the new tyre pressures on the in
fotainment system¢
page 235.
ffim
(Tyre Pressure Monitoring System)
Tyre
pressure: fault. See owner's manual
- If� ap
pears and the indicator lamp
[Bl
in the instru
ment cluster display flashes for approx. one mi
nute and then remains lit after you have switched
on the ignition or while you are driving, there is a
fault in the system. Try to store the correct tyre
pressures¢
page 235.
If the indicator lamp
does not go out or if it comes on again after a
short time, drive to a qualified workshop without
delay and have the fault rectified.
&_
WARNING
- If the tyre pressure loss indicator appears
on the display, slow down immediately and
avoid any severe braking or steering ma-
Wheels and tyres
noeuvres. As soon as you can do so safely,
stop and check the tyres and the tyre pres
sures.
- It is the driver's responsibility to ensure that
the tyre pressures are correct. For this rea
son you must check the tyre pressures regu
larly.
- Under certain conditions (e.g. driving at
high speeds, on ice and snow or on poor
road surfaces) the tyre pressure loss indica
tor may not appear immediately.
- Run-flat tyres* may only be used on vehicles
which were originally equipped with this
type of tyre.
- If a malfunction occurs in the ESC system,
the tyre pressure loss indicator may also be
out of action.
- When driving with snow chains, a system
malfunction can occur.
- The tyre pressure loss indicator on your Audi
is specially matched to tyres with the mark
ing "AO" or "RO"¢
page 231.
We recom
mend that you use these tyres.
Storing tyre pressure settings
Applies to vehicles: with tyre pressure loss indicator
When you change a tyre or the tyre pressure on
your vehicle, you must confirm the change on the
infotainment system.
� Before storing the new tyre pressures, check
that the current pressures on all four wheels
correspond to the specified values and adapt
the pressures to the current load ¢
page 232.
� Switch on the ignition.
� Select the following on the infotainment sys
tem:
I
MENU
I
button
>Car>
left control button
>
Servicing
&
checks> Tyre pressure loss indi
cator.
@
Note
Do not store the tyre pressures if you are driv
ing with snow chains. Otherwise, a system
malfunction may occur .
235
Содержание TT Coupe 2014
Страница 1: ...Owner s Manual Audi TT Coupe Audi Vorsprung durch Technik ...
Страница 2: ......
Страница 8: ...View of cockpit View of cockpit Controls at a glance 6 ...
Страница 284: ...Owner s Manual Audi TT Coupe Englisch 09 2014 152 561 SFV 20 IIIllII 1111111111111111 1525618FV20 www audi com ...