AUDAC R2, Руководство пользователя

Страница: 52 / 60

52
1) Connect the first R2 of your setup to your Ethernet network
2) Set the address for the first R2 to “R001”, this can be done in the “Setup” menu,
under “R2 Address Settings”.
3) Change the IP address for the first device to one which is available in your
ethernet network (For example 192.168.0.191). This can be done in the “Setup”
menu, under “Network Settings”.
4) Disconnect the first R2 of your setup from the Ethernet network
5) Connect the second R2 of your setup to your Ethernet network
6) Set the address for the second R2 to “R002”, this can be done in the “Setup”
menu, under “R2 Address Settings”.
7) Change the IP address for the second device to one which is available in your
ethernet network (For example 192.168.0.192). This can be done in the “Setup”
menu, under “Network Settings”. Make sure this IP address is different from the
first device’s IP address.
8) Disconnect the second R2 of your setup from the Ethernet network
9) Give all the R2’s in your setup an unique bus and IP address. This can be done by
repeating step 5 to 8 of this procedure. Make sure every device has an unique bus
and IP address.
10) Now, all devices have an unique bus and IP address, and no device is connected
to the Ethernet network.
11) Connect all devices to your ethernet network
12) Connect the R2’s with each other through fiber conductors, using the loop
principle as shown in Figure 1.
13) Restart all R2’s
14) All R2’s should display now “Fiber OK” on top of their main page, next to the
connection status.
Example setup with 5 R2’s, on the left side with only one Ethernet connection (Method 1) while on the right
side every R2 has a separate ethernet connection (Method 2)
R2
R2
R2
R2
R2
R001
R002
R003
R004
R005
R2
R2
R2
R2
R2
R001
R002
R003
R004
R005
Ethernet
192.168.0.191
Ethernet
192.168.0.191
Ethernet
192.168.0.192
Ethernet
192.168.0.193
Ethernet
192.168.0.194
Ethernet
192.168.0.194