AUDAC R2, Руководство пользователя

Страница: 30 / 60

30
Paging Settings
Settings >> Priority settings
The priority settings menu makes it possible to configure the priority channels. On top of this
window, all priority inputs are displayed ranging from Priority 1 to Priority 4. The input selected
for Priority 1 has the highest level of priority, the input selected for priority 4 has the lowest.
Note: On all Audac devices, priority settings always have priority over paging.
Priority input selection
You can select the desired priority channel by clicking on the corresponding button on
top of the window, and switching them on and off can be done by clicking the “Enabled”
button. When the priority is enabled, this button will turn green.
On the left side of this window, there are a “Trigger” and a “Input” dropdown list displayed.
In the “Trigger” dropdown list are all the inputs shown on which the priority can be triggered.
This ranges from the direct line inputs to the fiber and wall panel inputs as well as the internal
test signals. In addition to these input signals four priority inputs are displayed (two priority
signal inputs and two priority contact inputs). Here you can select on which input signal the
priority needs to be triggered. When an priority audio input is selected, there will be switched
to priority when an audio signal is present on these inputs. When a contact input is selected,
there will be switched to priority when a contact is made between those two pins.
In the “Input” dropdown list below, there can be selected which input signal has to be patched
when a priority situation occurs. In this list, the two direct priority audio inputs, the regular
direct RCA inputs, the Wall panel inputs, the Fiber inputs, but also the DSP and other input
signals are displayed.
On the right side of the window is a list of all output channels displayed. In this list can be
selected to which output zones the priority channel needs to be patched. This can be done
by simply clicking the button next to the channel. When the priority signal for this zone is
enabled, the button will turn green.