AUDAC R2, Руководство пользователя

Страница: 45 / 60

45
Configuration
To make the entire paging system work acording to the needs of your project, a
configuration procedure should must be followed.
Paging volume
The paging volume can be different for every zone, and should be configured individual
for each specific zone. To configure the paging volume, go to the “Setup” menu, and click
the “Paging volume” button. By means of dropdown boxes, the paging volume for every
specific zone can be set. Any changes must be saved.
APM configuration
The paging settings are stored inside the APM’s internal memory. For configuration, the
APM should be connected to the R2, and the configuration should be done through the
web based user interface of the R2 or via the Audac system manager. You can find the
paging configuration settings in the “Setup” menu, under “System configuration”, and
“Paging”. On the left side of the window are the settings for configuration of ARU’s shown,
while on the right side the settings for configuration of the APM’s are shown. Follow the
procedure below to make your paging system work successful.
1) Select the address which you want to assign to your paging console.
Select the address by the dropdown box, and click the “Set Address” button. Now, the
“PTT” (push to talk) button on all connected APM’s will start blinking. After pushing the
“PTT” (Push to talk) button the address will be assigned to the selected APM. For more
information regarding the APM address, see “Priority in chapter 6”.
When multiple APM’s are connected to one R2, it’s better to assign an unique address to
every APM, before continuing with the configuration procedure.
2) Select the APM and the amount of layers (only applicable for or APM116MKII)for your
configuration.
Press “New Configuration”. After pressing this button, you will be redirected to a new
window where you can select which APM you want to configure. Two dropdown boxes
are shown, by means of the upper one the R2 whereto the APM is connected should be
selected. When only one R2 is used, only “R001” will be shown. By the lower dropdown