ATX AL-FF-100, Руководство пользователя

Страница: 4 / 13

Ordering Information
Control 50 cfm slim 70 cfm slim 80 cfm 100 cfm slim 100 cfm
Wall Switch 3 inch 3 inch 4 inch 3 inch 4 inch
AL-WS-DR2 AL-FF-50D AL-FF-70D AL-FF-80D AL-FF-100SD AL-FF-100D
AL-WS-DR2C AL-FF-50 AL-FF-70 AL-FF-80 AL-FF-100S AL-FF-100
AL-WS-Bath AL-FF-50B AL-FF-70B AL-FF-80B AL-FF-100SB AL-FF-100B
Powering the Wall Switch
Power the switch via either of the 2 power input connectors, 48 to 56v is recommended. You can pass power thru
from one set of power connectors to the other to avoid wire nuts in the box, up to 2 amps. After power up – the
first time the switch is operated you will see a flicker while it learns the capability of the attached LED. After that
phase – the result is stored in on-board EEprom and will be updated for temperature and aging changes or each
time the slider is moved to low dim. When used with a 51 volt supply, voltage drop of up to 3 volts ( 150 ft of
AWG18 wire) has no impact even with 60 watts of LED loads.
Series LED wiring
The LEDs are wired
in series
The simple strip and poke OJ-
606 connectors are easy to
install in ceilings.
If you only cut the Red wire –
you can save time and work
by wiring as shown at left.
From 1 to 5 LEDs can be
connected on each side.
Set the jumpers for 300,
360,660 or 720 mA
Note: for 6 watt LEDs:
a) 5 in series at 660 mA / 51v
b) 4 in series at 660 mA /48v
c) 2 in series at 360 mA
Trouble Shooting
If the LEDs do not turn on at full brightness, or flash – please check common causes;
1. Flashing the first time the light is turned on, or if the number of LEDs per side changes, is part of self calibration, please
wait 1 minute for this to complete.
2. If no light – then the number of series LEDs is exceeded. The forward voltage of the LEDs is too great. The delivered
voltage is between 7 and 42 volts ( with a 48 v supply) or 46 volts ( with a 51 volt supply). Check the forward voltage of
the LEDs and add them up. For example, a 6 watt 360 mA bulb has 18 volts forward, a 6 watt 660 mA bulb is 9v.
if your LEDs add up to more than 42 or 46 volts - they will not turn on at full brightness, and might not turn on at all.