ATTO Technology iPBridge 1550, Инструкция по установке и эксплуатации

Страница: 40 / 72

31
ATTO Technology Inc. iPBridge Installation and Operation Manual
6.1 ExpressNAV pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topic. Each page can be reached through the menu at the side of each page. An image
on each page’s header shows each port in the product faceplate. Each port is clickable and takes you to
the appropriate page.
Status
Displays iPBridge information
• Vendor ID, product ID, firmware revision number
and serial number
• Ethernet port IP address and status
• SCSI
port status
Serial Port Configuration
Configures the baud rate and echo parameters. Refer to
Serial port configuration commands on page 47 for
details on each option.
Time & Date Configuration
Manually changes the iPBridge clock or accesses
a remote time server. Configurable options are
• enable or disable Simple Network Time Protocol
• Time
Server
• Time Zone
If you set the time and date manually, the time and
date will revert to the default if the unit is powered
offer. Refer to
Maintenance commands on page
41 for details each parameter.
Ethernet Port Configuration
Configures each port independently for the following
parameters and controls VLAN:
• enable or disable DHCP
• IP address, gateway, subnet mask and Ethernet
speed
• MTU
• iSCSI
port number
• VLAN ID and name
Remote Management
Remote system monitoring is available using
Simple Network Management Protocol (SNMP).
Refer to
Remote system monitoring on page 21
for more information. Refer to Diagnostic
commands on page 43 for detailed information.
SCSI Configuration
Controls the SCSI port for the following parameters:
• Bus speed
• Sync transfer
• Wide transfer
• Initiator ID
• Bus reset on startup
• Bus
termination
• Maximum LUNs for each SCSI Target
Attached devices are listed for each bus and you can
reset each port from this screen.
Refer to
SCSI configuration commands on page 45.
iSCSI Configuration
Controls the following iSCSI parameters:
• iSCSI Alias
• enable or disable iSNSLoginControl
• iSNS
Server
• enable or disable SpeedWrite
Refer to iSCSI commands on page 51 for details on
each parameter.
Automatic iSCSI Target Management
Choose to map devices automatically to the
default target or map each device to its own target.
By default, access control and CHAP are
disabled.
After you choose the target management method,
the
iSCSI Target Management page opens.
From the pages following you can configure
access control, device maps, iSCSI CHAP and
discovery sessions.
Refer to
Target management
on page 13, and
Target management commands
on page 53 for
details.
iSCSI Target Management (Manual)
Allows you to set up and configure iSCSI targets
individually for access control, device maps and
iSCSI CHAP depending on the choices you make.
Refer to Target management on page 13, and Target
management commands on page 53 for details.