5
6
Click
Next
. If a DHCP server is available on
your network, an address is assigned
automatically by the server. Note the assigned
address: ___________________________
If you do not have a DHCP server: refer to the
IP address, subnet mask and Gateway
address previously obtained from your
network administrator, type it into the area
provided and click Next. Select OK to restart
the FibreBridge and wait 1 minute while the
FibreBridge reboots. The Management Port
that is directly connected to the computer is
now configured and ready to be used.
7
Click on
Launch Browser.
Result: The ATTO
ExpressNAV interface welcome screen
appears.
Note
If the setup computer does not have its own IP
address, ExpressNAV will not launch. Either
enable DHCP and obtain an address from the
DHCP server, or request an IP address from
your network administrator.
(The subnet mask and Gateway IP address
should match the settings on the FibreBridge)
Consult the Product Release Notes for your
firmware version for a list of supported
browsers.
8
Go to step 10.
9
To configure an Ethernet Management Port
using CLI, connect a serial cable to the
FibreBridge and enter the following commands.
Use parameter mp1 to configure Management
Port 1 and mp2 for Management Port 2: The
‘info’ command shows if the FibreBridge
already has an IP address, subnet mask and
Gateway address for the Management Port. If
not, use the values obtained from your network
administrator and enter the following
commands:
set IPDHCP [mp1 | mp2] disabled
set IPAddress [mp1 | mp2] xxx.xxx.xxx.xxx
set IPSubnetMask [mp1 | mp2] xxx.xxx.xxx.xxx
set IPGateway [mp1 | mp2] xxx.xxx.xxx.xxx
SaveConfiguration
Restart
Then wait 1 minute while the FibreBridge reboots, and
verify your changes with the 'info' command.
10 If you use Internet Explorer as a browser, you
may continue on to the optional
Internet
Explorer setup
below. If not, continue on to
Configure the FibreBridge
.
Internet Explorer setup
1
Open your browser
2
Select
Internet Options
.
3
In the
Internet Options
screen, select the
Security
tab.
4
Click on the
Trusted Sites
icon.
5
Click on the
Sites
button.
6
In the text box
Add this web site to the zone
,
add the IP address of the appliance. You may
use wild cards.
7
Click on
Add.
8
Uncheck the
Require server verification
check box.
9
Click
OK.
10 At the bottom of the
Internet Options
box, click
on
OK
and close the box.
