25
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
5.1 ExpressNAV Pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on specific topics. Each page can be reached through the menu on the left hand side of each page.
Status
General information:
• Unit Information including Vendor ID, Product ID,
Firmware Revision and Serial Number
• Environmental
information
• World Wide Identifiers including Node Names and
Port Names
• Host Interface Card Status
• Fan
Status
• Power Supply Status
• Storage Status including ATA Disk Errors and Logical
Unit Conflicts
Ethernet
Configures the Ethernet port. Configurable parameters
are:
• IP
Address
• IP
Gateway
• IP
Subnet
Mask
• Ethernet
Speed
• Use
DHCP
See
Ethernet Access: Telnet and SNMP Protocols
on
page 21 for details.
SNMP
Remote system monitoring is available using Simple
Network Management Protocol (SNMP).
See
Ethernet Commands
on page 33 for details on each
parameter.
Serial Port
Allows you to configure the serial port. Configurable
options are
Baud Rate
and
Echo
See
Ethernet Access: Telnet and SNMP Protocols
on
page 21 for more information.
Fibre Channel
Manages the Fibre Channel port.
• Data
rate
• Full
duplex
mode
• Connection
mode
See
Connecting a Fibre Channel Array
on page 11 for
more information.
Storage Management
Displays information about the drives and their status
including
• Sled
Number
• Capacity of each sled
• Number
of
errors
• Type of configuration (RAID level)
• Virtual
Disk
ID
You may place sleds on or off line by selecting or de-
selecting a check box.
See
Drive Management Commands
on page 41 for more
information.
Once you open this page, other configuration pages are
available on the menu on the left hand side of the page.
RAID
Configures RAID groups. Information provided
includes
• Type of configuration (RAID level)
• Virtual
Disk
ID
• Number
of
partitions
• State of sleds
• Capacity
of
sleds
• Interleave
values
Configurable options are:
• RAID
Level
• Number of tape volumes
• Number of tape drives
• Hot
Spare
sleds
From the
RAID
page, go to
RAID Rebuild
Configuration
to change
• Interleave
• Rebuild
state
• Enable/disable auto rebuild
See
Configuring the Diamond-VT
on page 47 for more
information.
Clear Data
• view the status of any
Clear Data
command
• view the rebuild state of each sled
• initiate a RAID Level 5
Clear Data
command
See
Drive Management Commands
on page 41 for more
information.
Содержание Diamond Array VT
