ATTO Technology Diamond Array VT, Инструкция по установке и эксплуатации

Страница: 32 / 96

21
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
4.3 Ethernet Access: Telnet and SNMP Protocols
The optional 10/100 BaseT Ethernet port provides Telnet- or SNMP-based monitoring and management.
The 10/100 Base T Ethernet management services
card provides Telnet-based monitoring and
management, including firmware update using
FTP.
Remote system monitoring is also available using
Simple Network Management Protocol (SNMP).
An agent resides in the Diamond-VT which takes
information from the Array and translates it into a
form compatible with SNMP. If certain conditions
arise, the agent sends asynchronous notifications
(traps) to a client.
To connect to the Ethernet port
1 Connect a cross-over cable (for a direct
connection to a PC) or regular network cable
from a network device to the optional RJ45
Ethernet port on the Ethernet management
card on the front of the Diamond-VT.
2 If using a direct connection, power on and boot
up the host computer.
3 Attach a DB-9 null modem serial cable (the
cable must be no longer than three meters)
from the RS-232 port of the Diamond Array to a
host computer and open a terminal emulator
program on the host to set the Ethernet
parameters.Turn on the Diamond-VT.
4 First time use : Upon successful power up and
diagnostics, set the host computer with the
appropriate settings.
The host computer must have appropriate
network settings to allow it to communicate with
the Diamond-VT. Please see your system
administrator for more information.
To use Telnet
1 If you have not already done so, change the IP
address from the default by first accessing the
serial connection and using the CLI.
You may change the IP address to a network
specific value or, if the local network uses
DHCP, you may enable automatic IP
addressing
( set IPDHCP enabled ) using the
CLI.
2 Open a Telnet session on the host computer.
• IP address
• Port type: telnet
• Terminal type: vt100
3 If you make any changes to the network setting
on the Diamond Array, use the
SaveConfiguration Restart command.
4 Username/password: You are prompted for a
username and password, up to eight characters
each, case insensitive. Only one
username/password combination is available
per Diamond-VT.
• You may change the telnet username and/or
password after entering a CLI session using
the commands
set TelnetUsername [username]
set TelnetPassword [password]
• Or you may change the telnet username
and/or password using the Configuration
page of the ExpressNAV interface.
• The default username is telnet and default
password is diamond
.
5 In the Command Line Interface mode, see a list
of available commands by typing
help at the
Ready prompt or refer to
Summary of CLI
Commands
on page 29.
6 Using the ExpressNAV interface, configure the
unit as RAID Level 10 or RAID Level 5 with
zones and/or Hot Spare sleds as described
later in the manual.
To use SNMP
1 Enter the Command Line Interface through the
serial port or Ethernet.
2 Change the IP address to a network specific
value or, if the local network uses DHCP,
enable automatic IP addressing.
3 Set the number of trap client addresses by
typing
set SNMPTrapAddress [1-6]
[IPAddress] [Level]
4 Type set SNMPUpdates enabled .
5 Type set SNMPTraps enabled .
6 Type SaveConfiguration restart to reboot the
Diamond-VT.
7 Install SNMP management software on each
client you wish to receive traps (messages).