ATTO Technology ATTO FibreBridge 2350C, Инструкция по установке и эксплуатации

Страница: 74 / 109

63
ATTO Technology Inc. FibreBridge Installation and Operation Manual
RouteOnline
Updates the status of the selected route to online if a
device is found or unavailable if a device is not found at
the SCSI address. If route is not currently mapped,
command results in an error message. Not available on
the FibreBridge 2400.
Set syntax: set RouteOnline [fp] [fl]
Get syntax: get RouteOnline [fp] [fl]
SCSIInitID
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified SCSIInitID must be set to
offline and
will become invalid upon issuing this command. The set
command always modifies NVRAM, whether you use a
SaveConfiguration command or not.
Default: 7
Set syntax: set SCSIInitID [sb [0-15] ]
Get syntax: get SCSIInitID
SCSIInitID (FB 2400 only)
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified SCSIInitID will be destroyed after the
command is issued.
Default: 7
Set syntax: set SCSIInitID [sb [0-15] ]
Get syntax: get SCSII
SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port. Also, for all models except the
FibreBridge 2400, updates the status of any
online
maps/routes to unavailable if a device is not found or
online if a device is found.
Immediate: SCSITargets [sb]
ServicesLUN
Sets and displays the Services LUN for the specified Fibre
Channel port. Valid ServicesLUN entries are 0 through
(n-1) where n equals the number of Fibre Channel ports.
Valid entries for
fl are 0-63. Any map coinciding with a
user-specified ServicesLUN must be set to offline before
trying to change a ServicesLUN.
Set syntax: set ServicesLUN [[fp] [fl] | [disabled] ]
Requires a SaveConfiguration command
Get syntax: get ServicesLUN [fp]