ATTO Technology ATTO FibreBridge 2350C, Инструкция по установке и эксплуатации

Страница: 45 / 109

34
Interfaces: ExpressNAV
• Boot scan
• Boot scan ports
• Boot
Fibre delay
• SpeedWrite default
• Virtual drive response
• FC initiator mode
See Fibre Channel configuration commands on
page 55 and SCSI configuration commands on
page 53 for details on each parameter.
Time & date configuration
Configures the real-time clock or access remote
time server. Configurable options are
• Enable/disable Simple Network Time Protocol
• Time
server
• Time zone
• manually set time
• manually set date
See Maintenance commands on page 51 for
details.
Mapping
You may map drives using the ExpressNAV
Mapping page. See
Mapping on page 67 and
Mapping commands on page 61 for details.
Bridge management
Configurable options are
• User name
• Old Password
• New Password
• Confirm Password
• Minimum Operating Temperature
• Maximum Operating Temperature
• Operating Temperature Warning
• Identify
Bridge
• Restore Defaults
See Maintenance commands on page 51 for
details.
Advanced CLI configuration
Allows you to input any CLI command available
through the FibreBridge.
To use the Advanced Configuration page
1 Type in the CLI command
2 Click the Submit button: this is equivalent to
typing in the CLI command into a TCP/IP or
serial port CLI session.
A text field beneath the box will list the most
recent commands issued to the FibreBridge
through this page.
If you enter an incorrect parameter, the CLI
help text will be displayed, showing the
parameters available.
3 If your entry was correct, type
saveconfiguration
4 Click the Submit button. Your changes will be
implemented.
Update firmware (FB 2400 only)
Updates firmware. Follow the instructions on the
page.
CAUTION CAUTION
Before beginning this procedure, ensure
that all I/O to the FibreBridge has stopped.
Refer to Updating firmware on page 79 for
details.
Restart firmware
Implements a firmware restart of the bridge and
makes permanent any changes you have made
since the last firmware restart.
CAUTION CAUTION
Restarting the firmware may take a few
minutes.
1 Click the Restart button.
A box will tell you to wait until the counter gets
to 0 and then the browser will refresh.
2 If the browser does not refresh after the counter
gets to 0, click the link to refresh it manually.
Help
Gives help information about the command line
interface commands and troubleshooting tips via
links to pages with help text for each category of
options and one link to the Troubleshooting Tips
and FAQs page on the ATTO website,
www.attotech.com
.
Contact information for ATTO technical support
is on the right. Help is always available by
pressing any word shown in red on the screen.