![ATTO Technology ATTO FibreBridge 2350C Скачать руководство пользователя страница 44](http://html1.mh-extra.com/html/atto-technology/atto-fibrebridge-2350c/atto-fibrebridge-2350c_installation-and-operation-manual_3005602044.webp)
33
ATTO Technology Inc. FibreBridge Installation and Operation Manual
2.1.2 ExpressNAV pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topics. The exact settings available depend on the model of FibreBridge you are
using. ExpressNAV is not available for the FibreBridge 1180.
Screens in the ATTO ExpressNAV interface can
be reached through the menu at the side of each
page or through the image on each page’s header
which shows each port in the product faceplate.
Some screens and parameters are not available for
all FibreBridge models. Use the following as a
guide only.
Status
Displays FibreBridge information
• Vendor
ID
• Product
ID
• Firmware revision number
• Serial
number
• Valid
temperature
range
• Current
temperature
• Node
name
• Port
name
• Fibre Channel port status
• SCSI port status
Ethernet port configuration
Configures each port independently for the
following parameters
• IP
address
• IP
gateway
• IP subnet mask
• Ethernet
speed
• DHCP fixed delay
See
Ethernet configuration commands
on page 59
for details.
Serial port configuration
Configurable options are baud rate, echo and stop
bits. See
Serial port configuration commands
on
page 58 for details.
SCSI configuration
Each SCSI port is configured separately. Displays
include a list of attached devices for each bus.
Configurable options are
• Port
bus
speed
• Synchronous
transfer
• Wide
transfer
• Initiator
ID
• Selection
timeout
• Tagged command queuing
• Bus reset on startup
• Bus
termination
• Attached devices listed by bus number
Click on the individual bus for information on
each SCSI device.
See
SCSI configuration commands
on page 53 for
details.
Fibre Channel configuration
Configurable options on the port independent
options page
• Data
rate
• Full
duplex
• Connection
mode
• Arbitration
fairness
• Hard address assignment
• Fibre Channel class 2
• Ack
0
• FCP-2
compliance
• FCP-2 confirmation IU requests
• Accept
CRNs
• Busy
status
return
The node name, port name and a list of attached
devices are displayed on the port specific options
page. the following options are configurable
• Node
name
• Port
name
• Target
LUN
• Services
LUN
• Hard
address
• List attached devices
See
Fibre Channel configuration commands
on
page 55 for details on each parameter.
Storage management
A list of attached SCSI devices and a list of
attached Fibre Channel devices are displayed.
Click on the individual bus or port for detailed
information on each device.
You may also reset SCSI ports on this page.
The following options are configurable
Содержание ATTO FibreBridge 2350C
