US
-
2000
(
DCP 2000 V
V5)
SERVICE MANUAL
CE
Fertigstellung: 02.16
US-2000
g
g
Serviceanleitung_US2000V5_EN_V0.0.docx
Page 20 of 23
3.1.2 Tape End Sensor
This sensor is located inside the lower machine cabinet on the right side. A roller rides on top of the banding on
an upper dancer roller. If the banding would run out, the sensor wheel lowers into a groove cut into the roller and
reports the tape end. Tape End is a fault 3 condition. The error message will be displayed on the screen. A mis-
threaded machine may also result in a Tape End fault.
3.1.3 0 Point Sensor
Finds the “0” point or home position of the machine. The machine’s
0 point is the starting point when you first turn the machine on. The
sensor is located above and just to the right of the M1 motor. If this
sensor is bad, the red LED on the sensor will not illuminate in the
home position. The machine will run twice in the forward direction,
then once in reverse, looking for the home position. The fault will be
displayed on the display screen.
3.1.4 S7/S8 Sensors
These switches work opposite of each other to indicate arch position. The top switch
will indicate an open arch, while the lower switch will indicate a closed arch.
O-Point
Sensor
