US
-
2000
(
DCP 2000 V
V5)
SERVICE MANUAL
CE
Fertigstellung: 02.16
US-2000
g
g
Serviceanleitung_US2000V5_EN_V0.0.docx
Page 16 of 23
2.10.
Driving shaft
The clutch shaft is driven by a spur gear wheel attached to the motor shaft. The required tape tension is
controlled by an electro magnetic clutch. An electro magnetic brake mechanism holds the drive shaft in position
during the welding process in order to ensure that the band is tensioned as required.
2.10.1. Removing the driving shaft
1.
Remove the bandmotor.
2.
Remove the rubber roller release lever.
3.
Disconnect the brake and clutch wires from their terminal connections.
4.
Remove the fixing screw of the feed roller.
5.
Remove the 3 fixing screws on the bearing housing.
6.
Pull the whole driving shaft out of the unit, while you hold the feed roller.
7.
Put the key back in to the driving shaft.
8.
Out of the unit, you can put the driving shaft back into the feed roller.
Rubber roller release lever
Fixing screw of
f
the driving
g
shaft
g
