Atrump A1-3T, Руководство по эксплуатации, Страница: 26 / 37

26
WEEKLY
▲
Check and clean filters on heat exchanger
▲
Perform necessary cleaning of machine. Do not use
solvents
▲
Apply a little grease on the Geneva cam and rails for
armless type tool changer system.
MONTHLY
▲ Check way covers work properly and lubricate with light
oil. Clean up the upper filter of the coolant tank if needed.
▲ Use grease for fingers and pocket of tools for ATC
system.
SIX MONTHS
▲ Replace coolant and clean up the coolant tank
▲
Check coolant is sufficient by the flowmeter on the tank.
▲
Apply Mobil Vactra #2 oil on full length of chain for
counterweight.
▲
Check the chain on the counterweight condition, if there is
wear out or cracks
▲ Inspect if there is any chips attached on 3 axis sliding
way.
ANNUALLY
▲
Make sure the ground bond test resistor value meet
standard.
▲ Drain out oil from spindle chiller tank, and then refill
new oil. (if applicable)