Atrump A1-3T, Руководство по эксплуатации, Страница: 23 / 37

23
3.4 Machine Leveling
1. Home machine on 3 axes, X, Y, Z. Move table to center .
2. Install the leveling bolts and screws and put the leveling pad under the
machine. Make sure the leveling bolts are located in the indent of
leveling pad.
3. Clean the table surface and put the levels on it. (Ref. Fig. 3.6)
圖
fig 3.6
機器水平調整
Adjusting Level
4. Adjust 4 corner leveling screws ensure air bubbles of 2 levels stay in the
middle.
5. Move the saddle to the front (Y axis), adjust front leveling screws and then
move the saddle to the back, adjust the back screws. Repeat this step if
necessary and ensure all the travel (front to back) difference is /- half
degree (
± 0.05mm)
6. Move the table (X-axis) to left, adjust left foundation screws. Move Table (X-
axis) to right (See Fig. 4), adjust right foundation screws. . Repeat this step if
necessary and ensure all the travel (Left & Right) difference is /- half
degree (
± 0.05mm)
7. Adjust the center leveling screws to touch the level pad.
8. Tighten all leveling bolts and screws.