Atmel AT32UC3L QMatrix, Примечание к применению

Страница: 21 / 36

Atmel AVR8015
21
32185A-AVR-01/12
10. Notice that the wheel has been assigned to channels 0-3.
11. Notice the toolbar on the top left corner of the virtual kit window which is shown in
Figure 4-26 is used for adding wheels, sliders and buttons. Click on those icons
to add the corresponding sensor.
12. Add the sliders, wheels and buttons in the sequential order as displayed on the
sensor board.
13. Click on the slider icon and a slider gets added to the virtual kit. Similarly, click on
the wheel icon to add a wheel to the virtual kit. Refer to Figure 4-27 .
Figure 4-27. Adding a slider and wheel.
14. Ensure that the channel numbers are assigned in the following sequence:
Wheel 0: 0-3
Slider 0: 4-7
Button group 3 to 10: 8-15
Wheel 1: 16-19
Slider 1: 20-23
Button group 13 to 20: 24-31
Wheel 2: 32-35
Slider 2: 36-39
Button group 23 to 30: 40-47
Wheel 3: 48-51
Slider 3: 52-55
Button group 33 to 40: 56-63
Ensure the sensors are added to the project in the above sequence so that
the channels will also be assigned to the sensors in the above sequence.
15. Now adjust the height and width of the wheels and sliders.
16. Save the Design (File
→ Save Design) and close it.
Make a note of the project ID.
Make sure that the sensors have been assigned channels as mentioned
above.