Atlas Copco PHE 45 S, Инструкции по ремонту

Страница: 9 / 13

8
PAGE
Repair Instructions No.189.03/01
PHE 45 S
Assembling
the spindle
1
Lightly grease the inner wall of the cylin-
der (4) and push it over the piston (O) (the
piston is illustrated on page 7, pos.5, ill. 1).
2
Insert the cylinder (4) with the percussion
body (2), as well as the seal ring and the
O-ring (3) into the crankcase (5) and fas-
ten them with the four secured screws (1).
3
Insert the O-ring (N), the snap die (M), the
disk (L), the O-ring (K) and the disk (J) into
the spindle gear (G). Fit the disk (L) with
the phase facing the snap die. Mind the
right position!
4
Push the spindle sleeve (7) with the
O-ring (6) over the spindle gear (G).
5
Lock the spindle gear with the four
pins (H) using a magnet for support.
6
Mount the needle bearing (B), the disks (C
and E), the cup springs (D) as well as the
needle bearing (F) in the bearing end
plate (A).
7
Mount the locking ring (9) with aid of spe-
cial pliers.
8
Insert the seal ring (8) into the bearing end
plate (A).
9
Push the spindle sleeve (7) with the spin-
dle gear (G) into the bearing end plate (A).
Mounting the
bearing end plate
1
Push the backing flange (A) and the felt
washer (9) over the spindle sleeve.
2
Fit the gasket (2) and the bearing end
plate (1) completely with the spindle
sleeve to the crankcase (8).
3
Push the pressure spring (B) and the re-
taining plate (D) over the spindle sleeve
and depress them.
4
☞
Press in both locking levers (C) from
the side against resilience.
5
Push the distance sleeve (6) and the
sleeve (7) over the spindle sleeve.
6
Push the flange (E) over the spindle
sleeve (7) and fasten it tightly with the four
secured screws (F) (15 Nm).
7
Push over the distance sleeve (4) and the
sleeve (5).
8
Mount the cap (3).
D
1
6
5
4
3
2
7
8
9
A
B
C
E
G
H
F
J
K
L
M
N
0
3
1
6
5 4 3
2
7
8
9 A
B C D F
E
C
4