Atlas Copco CombiCutter CC 1501, Руководство по эксплуатации

Страница: 20 / 48

20
9.4. Limitations when cutting steel
Warning!
The hydraulic cutter is not suitable for cutting steel sheets and plates.
By the same token the hydraulic cutter must not be used to cut through tanks (oil tanks).
All steel sections of tensile strength < 370 N/mm2 can be cut using the hydraulic cutter.
Cutting higher steel grades e. g. rails for railways or streetcars, wire cables or spring steels may cause
damage to the hydraulic cutter.
Section CC 1501 U CC 1501 S CC 2100 U CC 2100 S CC 4000 U CC 4000 S
240 mm 280 mm 240 mm 300 mm 360 mm 400 mm
160 mm 180 mm 160 mm 200 mm 240 mm 260 mm
220 mm 300 mm 240 mm 320 mm 400 mm 400 mm
150/150/20 mm 160/160/22 mm 160/160/22 mm 200/200/24 mm 250/250/24 mm 250/250/24 mm
F 7 x Ø28 mm 9 x Ø28 mm 10 x Ø28 mm 10 x Ø28 mm 18 x Ø28 mm 20 x Ø28 mm
9.5. Instructions on the correct use of the hydraulic cutter
The hydraulic pulverizer may only be used for the applications described. (Refer to section 5)
The following examples show how to use the hammer correctly and draw attention to incorrect usage.
Warning!
K
Fig. 9
The hydraulic cylinders on
the carrier boom must
not
be retracted to their full ex
tent, since this could result
in damage to both carrier
and cutter.
K
Fig. 10
Warning!
The hydraulic cylinders
on the carrier boom
must
not be extended to
their full extent, since
this could result in dam
age to both carrier and
cutter.