Atlantic Ultraviolet Mighty Pure MP16A, Руководство пользователя, Страница: 6 / 24

6
I
NSTALLATION
SAFETY EQUIPMENT REQUIRED TO PERFORM TASK
1. Remove water puri fi er from shipping carton. Inspect water puri fi er, power cord and plug for damage. Do not operate if
there is any damage to the puri fi er, power cord or plug. Models MP16A through MP22A are shipped with the lamp already
installed, while the lamp in the MP36C and MP49C is packed separately. Keep the lamp aside for installation once the
puri
fi er has been properly installed.
2. Units occasionally experience damage in shipment due to the fragility of the quartz sleeve. It is, therefore, recommended to
inspect the water puri fi er for damage to the quartz sleeve after it has been removed from the shipping carton. Each end of the
unit as well as the inlet and outlet should be viewed to see if the quartz sleeve has experienced damage. If the quartz sleeve
shows signs of damage it should be replaced before the puri
fi er is pressurized. See “ Quartz Sleeve Installation, Cleaning
or Replacement” in the “Maintenance” section for the proper method of replacing the quartz sleeve in your water puri fi er.
3. The water puri fi er should be mounted horizontally on a fl at dry surface. Secure the water puri fi er using the mounting holes
in the ballast housing or with the optional wall mounting kit. The puri fi er should not be solely supported by its plumbing
connections.
4. The water puri fi er must be connected to the cold water line only.
5. Installation requires that a 5-micron sediment fi lter or fi ner be installed, in line, prior to the water puri fi er. The sediment fi lter
will stop or trap large particulates from entering the water puri fi er. Particulates may cause damage to the quartz sleeve, as
well as interfere with the puri fi er’s ability to disinfect the water. The sediment fi lter may also help to reduce the amount of
routine cleanings of the quartz sleeve.
6. Shut off valves should be installed on both the inlet and outlet sides of the water puri fi er. The use of bypass valves is not
recommended . The shut off valves allow the puri fi er to be isolated from the water supply, which is required when removing
the quartz sleeve.
7. Unions should be installed on both the inlet and outlet of the water puri fi er; this will allow easy removal of the water puri fi er
from the plumbing, if required. Apply Te fl on
®
tape to threads of inlet and outlet ports to ensure a tight seal.
8. When all plumbing connections are complete, allow water to enter the water puri fi er at a low fl ow rate, until the puri fi er is
full. NOTE: Close the puri fi er outlet valve to pressurize the chamber. With the puri fi er pressurized, it should be checked
for leaks. Once it is determined that there are no leaks, the inlet valve can be fully opened.
9. For Models with lamps packed separately, install lamp following the steps in “Lamp Installation or Replacement” section.
CAUTION: Lamp and quartz sleeve are easily damaged. Exercise care when handling. (Continued on Page 7)
Figure 2 - Recommended Installation