Atlantic Ultraviolet Mighty Pure MP16A, Руководство пользователя, Страница: 5 / 24

5
INSTALLATION
L
OCATION
1. The water puri fi er is intended for indoor use only. The water puri fi er is designed to mount horizontally. The water puri fi er
should be protected from the elements and from temperatures below freezing. The ambient temperature, in the area
surrounding the water puri
fi er, should be between 35
o
F and 100
o
F.
2. Electrical power supplied to the water puri fi er MUST match power requirements listed on the water puri fi er. Use of a voltage
surge protector is recommended.
3. CAUTION: Plug water puri fi er only into an approved ground fault circuit interrupt (GFCI) receptacle.
4. The water puri fi er should be located in a dry, well-lit area, which provides enough room to perform routine maintenance. This
includes a minimum distance of one chamber length from the chamber end, to allow for cleaning and/or the changing of the
lamp and quartz sleeve as well as a minimum of 6” on the opposite end of the water puri
fi er. Minimum clearance to fl oor 18’’.
5. The water puri fi er should always be located closest to the point of use. This reduces the chance of the puri fi ed water being
re-contaminated by bacteria in the water distribution system after the water puri fi er.
6. CAUTION: As with any water handling device, the water puri fi er should be located in an area where any possible
condensation or leakage from the water puri fi er, any puri fi er accessory and/or plumbing will not result in damage to the
area surrounding the water puri fi er. For added protection, it is recommended that a suitable drain pan be installed under the
puri fi er. The drain pan must be plumbed to an adequate, free fl owing drain to prevent water damage in event of a leak. There
are numerous leak detection/ fl ood stop devices, available on the market today, designed to stop fl ow of water, reducing the
chance of water damage due to leakage. For more details regarding leak prevention and/or limiting damages due to leaks
please contact factory.
7. The water puri fi er should be located after all other water devices, such as De-ionizers, Water Softeners, Carbon Filters, Pre-
Filters, Reverse Osmosis, Pressure Tanks, and Pumps. This reduces the chance of the puri fi ed water being re-contaminated by
bacteria in any of these units.
D
IMENSIONAL
D
ATA
Figure 1 -Mighty

Pure ® Dimensional Drawing
Table 2 - Mighty  Pure ® Dimensional Data
Model A B C D E F G H Inlet/Outlet
MP16A 8-3/4” 16” 8-3/4” 10” 16-1/2” 3-5/8” 4-5/16” 8-3/16” 3/4”m NPT
MP22A 14-3/4” 22” 13-1/4” 14-1/2” 22-1/2” 3-5/8” 4-5/16” 8-3/16” 3/4”m NPT
MP36C 28-1/2” 36” 16” 18” 36-1/2” 4-15/16” 5-11/16” 9-1/2” 1”m NPT
MP49C 40-7/8” 49” 26” 30” 49-1/2” 4-15/16” 5-11/16” 9-1/2” 1- 1/2”m NPT
All speci fi cations, dimensional data, etc are approximate and subject to change without notice.