Atlanta EVA, Руководство пользователя

Страница: 29 / 32

Atlanta Stretch S.p.A.
25
E54
Bottom limit switch error:
did not engage during
descent command
(creasing)
-The carriage blocked during
descent.
-Check motor operation.
-Check operation of the bottom sensor and
replace if broken.
-Make sure there are no mechanical obstacles.
E62 Presser carriage
descending but the
presser plate is out of
position, cannot detect
pallet (tables)
-Presser plate blocked. -Manually rotate the presser plate.
The presser plate cam must pass <2 mm from
the sensor. Check the correct operation of the
sensor, bringing a metallic object near it. If the
LED lights up, check the cable, if the sensor does
not signal anything, replace it.
E64
Presser carriage
pallet (Tables)
-The pallet is too low. -To wrap, exclude the presser.
E90
The entry photocell
engaged during transport
of a pallet on the rotating
roller unit (tables)
-Pallet out of position. -Reposition the pallet and check the photocell
operation.
E91
Attempt to start the
platform while a
photocell on the entry
and exit of the rotating
roller unit is engaged
(Tables)
-Pallet in transit. -Remove the pallet.
E92
Alarm, rotating roller unit
already engaged during
loading of a new pallet:
the photocells on the
roller unit must both
be free before loading
(Tables)
-Pallet unloading while a new one is
loading.
-First unload the pallet in transit, then load the
new one.
E93
Alarm detected non
standard pallet on the
rotating roller unit: the
photocells on the roller
are both engaged during
loading. (Tables)
-The pallet is too long. -Remove the pallet.
E94 Alarm, platform out
of phase during pallet
transport into and out of
the roller unit (Tables)
-The table was not set in phase. -Exit automatic mode and turn the table in phase.
E95
Alarm, exit occupied
while unloading the pallet
from the rotating roller
unit. The two photocells
on the unloading line are
both engaged. (Tables)
-The photocells are engaged. -Check the status of the photocells.