Atlanta EVA, Руководство пользователя

Страница: 28 / 32

Rev.0 13/01/2020
Operator Panel | TURNTABLE - MAST
24
E16 Emergency intervention -Emergency button pressed.
-Carriage door open. -Unblock the button and restore the power
circuit.
-Close the door and restore the power circuit.
If FE or FM carriage, check the bridge on the
connector. Check the emergency microswitch.
E20
Non-volatile memory
error functions (I2C) #0
-No response from memory. -Replace the memory I
2
C (24LC256).
E21
Non-volatile memory
error functions (I2C) #1
-Memory timeout. -Replace the memory (24LC256).
E22
Non-volatile memory
error functions (I2C) #2
-Communication error. -Replace the memory (24LC256).
E23
Non-volatile memory
error functions (I2C) #3
-Communication error. -Replace the memory (24LC256).
E24
Non-volatile memory
error functions (I2C) #4
-Memory occupied. -Replace the memory (24LC256).
E25
Non-volatile memory
error functions (I2C) #5
-Write error. -Replace the memory (24LC256).
E26
Non-volatile memory
error hidden parameters
(EE) #1
-Periphery occupied. -Replace the microcontroller (PIC).
E27
Non-volatile memory
error hidden parameters
(EE) #2
-Interruption during writing. -Replace the microcontroller (PIC).
E28
Non-volatile memory
error hidden parameters
(EE) #3
-Failed check given after writing. -Replace the microcontroller (PIC).
E29
Non-volatile memory
error hidden parameters
(EE) #4
-Timeout writing data. -Replace the microcontroller (PIC).
E50
Error in creasing position
sensors
-Both sensors are engaged. -Check the proper electrical wiring or proper
installation and mechanical operation.
E51
Creasing locked during
closure
-Creasing blocked on the top sensor. -Check motor operation.
-Check electrical connection
-Make sure there are no mechanical obstacles.
-Check sensor operation
E52
Creasing block during
opening
-Creasing blocked on the bottom
sensor.
-Check motor operation.
-Check electrical connection
-Make sure there are no mechanical obstacles.
-Check sensor operation
E53
Top limit switch error: did
not engage during ascent
command (creasing)
-The carriage blocked during ascent. -Check motor operation.
-Check operation of the top sensor and replace
if broken.
-Make sure there are no mechanical obstacles.