27
Chain catcher
Â
The chain catcher (30) prevents a broken or jumped off saw
ed.
chain from hitting the operator during sawing.
L
Check the chain catcher on a regular basis and replace
it if it is damag
Silencer / exhaust outlet
Â
Check the tight seat of the screws on the silencer (25) on a
regular basis
Î
If they are loose, tighten them hand-tight with the engine
in cold condition.
Do not retighten the silencer screws when the engine is
t.
ho
L
Clean the exhaust outlet on a regular basis
Adjusting the carburetor (idle speed)
the correct fuel-air mixture is fed to the engine.
in severe
engine damages. Do not continue working with the
ed) has to be
in idle speed)
-
Err
d
L
C
d have the carburetor
The carburetor is factory-set to the correct idle speed so that
An incorrect carburetor adjustment results
chain saw in such a condition.
In the cases below the carburetor (idle spe
corrected:
-
Speed too high (saw chain continues to move
atic running or lack of acceleration (idle speed too low)
justment to weather conditions and temperatures
ontact a specialist workshop an
-
A
adjustment done.
Cleaning
Clean the chain saw thouroughly after each application so that
ith a soft brush or a dry cloth.
the faultless function is kept.
B
Clean the case w
Water, solvents and polishing agents shall not be
applied.
Â
B
Make sure that the vent slots (32) of the cover (26)
ting).
aw using a
B
and the engine's cooling fins (33) for engine cooling are free
and clean (risk of overhea
B
If heavily contaminated, clean the chain s
commercial chain cleaner.
Â
Clean the oil flow canal (19) with a clean cloth or a
sh.
bru
B
Â
Clean the brake strap (20) at the cover (13) using a
brush.
T
T
r
r
a
a
n
n
s
s
p
p
o
o
r
r
t
t
Before each transport:
−
switch off device
−
wait for stop of chain saw
−
attach the scabbard on the guide bar
Â
Carry the product with the front handle. The guide bar
l
When transporting the product within a car put it in the boot
o
e the chain saw against
tip i
sha l show to the rear side.
or n a separate loading area. Secur
p ng over, damages and fuel spillage.
S
S
t
t
o
o
r
r
a
a
g
g
e
e
guarantee smooth
operation, before storing for a longer period:
B
Operate the engine
buretor is empty.
B
thoroughly clean th
longer
stem should be flushed
commercial chain saw
the
B
Aft
sho
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and
until the car
e device.
B
Empty the fuel tank completely.
B
Empty the oil tank completely.
B
C
Dispose of remainders of fuel/saw chain oil according
to relevant regulations (environmentally compatible).
Tipp:
ncrustations after a
Some chain oils tend to e
period. For this reason the oil sy
a
before a longer storing with
cleaner. Fill the cleaner up to the middle (appr. 50 ml)
into the empty oil tank. Close the tank. Operate the chain
ithout installed guide bar and chain until all of
saw w
cleaner came out of the oil outlet of the chain saw.
er cleaning, immerse the saw chain in an oil bath for a
rt time and wrap it then with oiled paper.
