Wireless F/T Installation and Operation Manual
Document #9620-05-Wireless FT-03
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati-ia.com • Email: [email protected]
36
REDPINE => Switch to RedPine Console Mode. Exit with +++
This is a special mode that allows you to communicate with the RedPine Console. This is used during radio
frequency acceptance testing.
RESET => Reset processor
This command resets the processor. Use with caution, especially if you are accessing the console through
Telnet.
RESTIP => Restore all IP settings to factory defaults
This command restores all IP settings to the factory defaults. Any changes take effect with the next Join to
an Access Point.
RSSI => display RSSI from AP
This command displays the RSSI value (in dBm) for the signal from the device that the Module is connected
to, as measured by the Module. RSSI (Received Signal Strength Indicator) is a measurement of the power
present in a received radio signal. For example:
>RSSI
WLAN: 00:19:59 RSSI from ATI_WIFI using External antenna: -45 dBm
SAVEALL => Save all calibrations & IP settings to Serial Flash
This command saves all calibrations and IP settings to Serial Flash, so that they will survive a processor
reset.
