Atheros AP222A, Руководство пользователя

Страница: 16 / 81

COMPANY CONFIDENTIAL 15
Variable Default Description
AP_BRNAME When assigning a VLAN to a VAP, a bridge instance is created for
the VLAN. This identifies the “name” of the bridge.
TXQUEUELEN 1000 Provides the number of transmit descriptors to be allocated for the
ath object. These are shared for all VAPs
SHORTGI
SHORTGI_2 1 Enables the short gating interval.
AMPDUENABLE
AMPDUENABLE_2 1 Enables AMPDU aggregation; applies to all VAPs attached to the
radio.
AMPDUFRAMES
AMPDUFRAMES_2 32 Maximum number of frames to include in the aggregated frame.
Applies to all VAPs attached to the radio.
AMPDULIMIT
AMPDULIMIT_2 50000 Number of bytes for the maximum size of the AMPDU packet.
AMPDUMIN
AMPDUMIN_2 32768 Minimum number of bytes to include in an AMPDU frame.
CWMMODE
CWMMODE_2 1 Setting for channel width management.
0
HT20 only
1 HT20/40
2 HT40 only
RATECTL auto Specifies if rate control is to be controlled automatically through the
rate control module.
auto
Automatic rate control
manual Manually set the rates and retry limits
MANRATE 0x8c8c8c8c This 32 bit hex number encodes the 4 rate table entries that are tried
on the link. This if manual rate control is enabled.
MANRETRIES 0x04040404 Number of retries on each rate interval to attempt before changing.
Only applicable if manual rate control
RX_CHAINMASK
RX_CHAINMASK_2 5 for 3 chain device
3 for 2 chain device Selects the chain mask to apply to the Receive path. The lowest 3
bits indicate the three antenna chains. This is for a “by 2”
configuration. This setting will override the setting in the EEPROM
of the device.
TX_CHAINMASK
TX_CHAINMASK_2 5 for 3 chain device
3 for 2 chain device Selects the chain mask to apply to the Transmit path. The lowest 3
bits indicate the transmit chains to include. This is for a “2 by”
configuration. . This setting will override the setting in the
EEPROM of the device.
AP_SSID# Atheros_Xspan_2G For the single VAP configurations, or the repeater case, only
AP_SSID is used. Default setting is as indicated.
For multiple VAP configurations, specifies the SSID for each VAP
instance (AP_SSID is VAP 1). If any of the variables are not
defined, the associated VAP will not be created. The AP_SSID_
x
variables should be defined in order. If AP_SSID_2 is not defined,
AP_SSID_3 should not be defined. For example, if you are creating
3 VAPs, do not define AP_SSID_4. If you are only creating two
VAPs, do not define AP_SSID_3 and AP_SSID_4.
AP_SECMODE# NONE Selects the security mode for the indicated VAP. One of “WEP”,
“WPA”, “WSC”, or “NONE”