ATEN VM0808HA, Руководство пользователя

Страница: 30 / 98

VM0808HA User Manual
18
(Continued from previous page.)
2. To disconnect an Output port from an Input port, press the corresponding
Output port pushbutton.
In the example below, Output port
2 has been disconnected from Input port
1 .
3. To switch to another Input port, press any Input port pushbutton. The
Output port LED(s) tied to the said Input port will flash.
In the example below, pressing Input port
2 shows it is tied to Output ports
3 and 4 .
4. To connect Output port 2 to Input port 2 in the example above, then press
the Output port 2 pushbutton. The Output port 2 LED will also begin to
flash (0.5 sec on, 0.2 sec off). This indicates that Input port 2 is now
connected to Output ports 2 , 3 and 4 .
Once the signal from the selected Input port is successfully tied to the Output
port, the LEDs turn off and the LCD information is updated.
Note: 1. Pressing an Input port a second time deselects it.
2. Input ports that are not configured or tied to any output port do not in
the LCD screen.
3. Pressing the Cancel pushbutton once stops the Input Port Selection
operation and the LCD displays the active setting. Pressing the
Cancel pushbutton again turns all LEDs off.
4. After 10 seconds of inactivity, all the LEDs turn off.