ATEN CS1842, Руководство пользователя

Страница: 31 / 88

Chapter 3. Basic Operation
19
Powering Off and Restarting
If it becomes necessary to power off the CS1842 / CS1844 unit, before starting
it back up, you must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch’s power adapter cable.
3. Wait 10 seconds, then plug the switch’s power adapter cable back in.
4. Once the switch is powered up, power on the computers.
Port ID Numbering
Each KVM port section on the CS1842 / CS1844 switch is assigned a port
number (1 or for the CS1842; 1 to 4 for the CS1844). The port numbers are
marked on the rear panel of the switch (see page 5 for details).
The Port ID of a computer is derived from the KVM port number it is
connected to. For example, a computer connected to KVM port 2 has a Port ID
of 2.
The Port ID is used to specify which computer gets the KVM, USB peripheral,
and audio focus with the Hotkey port selection method (see page 23 for
details).
Alternative Manual Port Selection Settings
When Hotkey Setting Mode has been activated, pressing [S] will invoke the
alternative front panel pushbutton manual port selection functions, as
explained below:

Press a port selection pushbutton once to bring only the KVM focus to the
computer attached to its corresponding port.

Press a port selection pushbutton twice to bring the audio focus to the
computer attached to its corresponding port.
Note: This function is disabled when the fast switching mode is enabled,
see
Switching Mode Selection , page 31.

Press and hold a port selection pushbutton for more than 2 seconds to
bring the KVM, audio and USB focus to the computer attached to its
corresponding port.

Press and hold port selection pushbuttons 1 and 2 for more than 2 seconds
to start Auto Scan Mode, see page 25 for details.