ATEN CCKM, Руководство пользователя, Страница: 259 / 466

Chapter 6. System Status
235
CCVSR
Important operations occur on the transmitter can be recorded using the
CCVSR program.
Check
Enable
to enable the CCVSR function and specify the
MAC address
and the
Service Port
of the computer the CCVSR runs on.
Note: The valid port range is 1–65535. The port number must different than
the one used for the
Program port (see Ports , page 234).
Mode
Use this section to set the working mode parameters.
 Enable ICMP : Check to enable ICMP service.
 Disable Browser Service
: Check to disable a particular access. Available
options are: browser, http or https.
 Enable Client AP Device List : Check to enable this function. When
enabled, the unit will be discoverable in the Server List when using the
WinClient or Java Client AP (see
Starting Up on page 325). Disabling this
function will render the unit undiscoverable in the Server List but can still
be connected to.
IPv4 Settings
The transmitter can either have its IP address assigned dynamically at boot-up
(DHCP), or it can be given a fixed IP address.
 For dynamic IP address assignment, select the DHCP radio button. (This
is the default setting.)

To specify a fixed IP address, select the
Manual
radio button and fill in the
IP address.
Note: 1. If you choose DHCP , when the transmitter starts up it waits to get its
IP address from the DHCP server. If it has not obtained the address
after one minute, it automatically reverts to its factory default IP
address, 192.168.0.61.
2. If the transmitter is on a network that uses DHCP to assign network
addresses, and you need to ascertain its IP address, you can use the IP
installer. See
IP Installer , page 420 for information.