ATEN CCKM, Руководство пользователя, Страница: 177 / 466

Chapter 2. Hardware Setup
153
Network Configuration
This section provides instructions to configure the network settings with a
fixed IP address, subnet mask, and default gateway. To use the
IP Installer
to
configure the IP address, see IP Installer , page 420.
Note: 1. Both devices are preconfigured with factory-default network settings.
If you install only one set of KE Series units, you do not need to
change these default network settings. See
Default IP Addresses ,
page 154, for further details.
2. In a network setup with multiple units, each transmitter and receiver
must be configured with a unique IP address. See Network
Configuration , page 153, for further details.
3. We recommend using 1000-Mbps Gigabit Ethernet switches (wire
speeds, non-blocking with 1 Gbps / 1.5 Mpps performance per port)
between devices installed on different LAN segments under a same
office network environment. 10/100 Mbps switches might cause poor
performance.
4. In multipoint configurations, the IGMP and flow control function of
your network switches/hubs must be enabled to avoid the
deterioration of data throughput. To ensure functionality use a layer 3
switch that supports IGMP queries.
5. If your network uses cascaded switches, please check to ensure the
data throughput is sufficient.
6. To get the best performance, we suggest creating a private network
for KE device, as they are bandwidth-intensive devices.
To configure the network settings, do the following:
1. Set up the hardware and connect the transmitter and receiver to the local
area network (see KE6900 / KE6940 LAN Installation , page 121, or
KE8950 / KE8952 LAN Installation , page 143).
2. From the receiver, tap [Scroll Lock] twice to invoke the OSD.
3. Select the Receiver or Transmitter from the sidebar menu.
4. Enter the password and click Configure .
The default password is: password .