ATECH ACK700, Руководство пользователя

Страница: 29 / 38

6. Place the PVC or aluminum profile that you will work with on the table (FIGURE 2 NO.26). Using the clamp trig-
ger switch (FIGURE 1 NO.17-4-2) located on the control Panel (FIGURE 1 NO.17) clamp the material with the
clamps (FIGURE 2 NO. 46/50) located on the set square.
7. The clamps operate pneumatically at ACK 700 models. You can adjust them backward & forward and up and
down (FIGURE 2, NO.48/49). Control of pneumatic clamps is made by buttons (FIGURE 1 NO.17-4-2) on the
panel (FIGURE 1 NO.17).
8. Adjust the clamping pressure setting of pneumatic piston with the switch (FIGURE 1, NO.17-6) on the control
panel.
9.
Close the top top guard (FIGURE 1 NO. 51) using the button (FIGURE 1 NO. 17-4-1) on the control panel. Cut-
ting operation can not be done on the machine without closing the protection cover and the clamp on the
grounds of safety.
10. Let the saw blade rotate by pressing the Motor Start button (FIGURE 1 NO.17-5) on the control panel.
11.
Provide the uplift of the saw by pressing on the double hand safety buttons (FIGURE 1 NO. 17-1) simultaneous-
ly. Continue to press the buttons until the part is cut off.
12.
Release the buttons after the cutting process is completed. The saw blade will move down to its start position.
13.
In particular, when aluminum material is cut through, it is recommended to use pneumatic spray mist lubrication
system. You can adjust the flow rate of the coolant by using the spray valve (FIGURE 3 NO.34-25).
14.
Open the top guard (FIGURE 1 NO. 51)
15. Take the part out after releasing the pneumatic clamps.
29