ATECH ACK700, Руководство пользователя

Страница: 33 / 38

6.
Provide the slackening of the belt (FIGURE 4 NO. 34-9) by pushing the Motor (FIGURE 4 NO. 34-6) upwards.
7.
Replace the existing belt with the new one. Be careful when fixing the belt to the channels of balancing wheel
(FIGURE 4 NO.34-7/34-5) of the channels of the belt.
8.
After installing the new belt in its seat, adjust the tension of the belt by turning belt tensioning part (FIGURE 4
NO. 34-8) with the help of 8 mm Allen wrench. After you set to the appropriate tension, tighten the motor con-
nection bolts (FIGURE 4 NO. 34-12) with your unused hand without leaving the part.
9.
Fix the removed parts by following the reverse sequence that your removed them before.
4. Angular and run out adjustment control of saw blade and set sguare
1.
Cut the electric connection of the machine.
2.
Control the run out of the saw blade with eyes. İ f possible use a dial gage.
3. If there is any problem in the inclined cut, control the saw’s 90 degrees orthogonal to the set square with the aid
of the set-square. If it is not proper, loosen the stay bolt at the top which tightens the spring (FIGURE 2 NO.63)
Have the pin located to its place by turning the spring in way that it can provide it to be proper by setting it to the
90 degrees. Tighten the screw at the top again which fastens the spring.
33