Cable Cover
Cable
6.1
Plug your cables into the
monitor and follow this cable
management system route.
6.2
Loop the cable
and push it through the
Forearm Cable Clip gap.
6.4
Push the cable up into the gap in the lower
arm Cable Cover.
6.5
Whilst maintaining pressure on the
cable, slide the cable into the groove and
follow it up.
6.6
Whilst maintaining pressure on the
cable, slide the cable into the groove and
follow it down.
6.3
At the Elbow, pull one
side of the clip down and
push the cable through
the gap.
5.2
Push the monitor down to
the bottom. If the screen bounces
back this may indicate too much
tension. Loosen the spring tension
1 turn at a time
until no bounce
is observed.
Once adjustments have been
made, move the arm assembly
through the full range of movement
to ensure it moves freely and holds
its position.
Spring Tension Gauge
Red Marker
Step 6. Cable Management
Step 5. Adjust Spring Tension (cont.)
5.3
MULTIPLE ARM INSTALLATIONS
When installing multiple SYSTEMA products using
monitors of the same weight, observe the location of
the
red marker
on the Spring Tension Gauge and
set the tension to the same position on all arms.
Note:
Ensure enough cable slack
is given to allow for movement.
Max weight: 8 kg.
