Coin Mechanism
Switch off power to the game. Unlock the coin door and swing it open. Unlatch and remove each
coin mechanism separately to clean or replace with a different type. Ensure that mechanism seats
fully in the holder upon reinstallation. Close and lock the release latch, then close the door. Turn on
the game and change the mechanism setup, then test known good and bad coins to verify operation.
Dollar Bill Validator
(Use JCM DBA
Dixie-Narco USA-15 or other U.L. Recognized currency changers)
Dollar bill validators or other currency acceptors may be installed in games manufactured with the
additional wiring connector
ready). Switch off power to the game and unplug the A.C. line cord.
Unlock the coin door and swing it open. Read the door label for additional information. Remove nuts,
spacers, and cover plate from the door. Change switch setting or other adjustments before mounting
the unit. If the manufacturer has supplied an adapter plate, place it over the door cutout at this time.
Install spacers on threaded studs, then align the validator mounting holes with the studs and seat the
unit in the door opening. Install the nuts and tighten firmly. Attach the ground wire (green with yellow
stripe) lug to the door ground stud next to the hinge. Mate the wiring harnesses and press to fully seat
connectors. Route wires away from door edges and hinge. Check for proper bill chute alignment.
Plug in the line cord and turn on the game. Change the mechanism setup and pricing, then test
known good and bad bills to verify proper operation. Close and lock the coin door when correct.
Monitor
Switch off power to the game. Open the control panel, remove the viewing glass and the monitor
bezel. Open the cabinet door and disconnect all monitor cables. Remove the four flange nuts
securing the monitor’s mounting brackets to its mounting panel. Pull the monitor carefully from the
cabinet and set in a safe place. Clean the face of the CRT before reinstalling the bezel and the glass.
CAUTION
THE VIDEO MONITOR IS HEAVY, WITH MOST OF THE WEIGHT TOWARD THE FRONT OF THE
ASSEMBLY. BE SURE
FIRMLY SUPPORTED AS IT IS REMOVED FROM THE CABINET.
The monitor does not require isolation from the A.C. line voltage in normal operation.
However, when operating outside the cabinet or servicing the monitor on a test bench, YOU
MUST ISOLATE THE MONITOR FROM LINE VOLTAGE WITH AN ISOLATION TRANSFORMER.
Power Supply
Switch off power to the game. Remove screws, then unlock and remove the rear door. Unplug the
IEC A.C. connector from the rear of the supply and the D.C. connector from the front.
Remove two
front and two rear screws from the supply, then lift off of the power chassis. Note the voltage setting.
To reinstall the power supply, set the voltage switch to the correct value. Set the supply on the power
chassis and align the mounting holes. Install the four screws and the two power connectors.
CPU Board Assembly
Switch off power to the game. Open the front door. If used, remove the RF Cage top to expose the
CPU Board Assembly. Carefully note the orientation of the
connector and the other cables of
the wiring harness. Extract the harness cables and the hard disk drive ribbon cable from the board
connectors. Remove the CPU Board Assembly mounting screws.
Lift the board out of the cabinet
and set in a safe place. Anti-static bags and protective containers from new parts may be used to
store the board if it is not reinstalled.
1-8
Содержание RAMPAGE WORLD TOUR
Страница 41: ...CABINET WIRING DIAGRAM 3 4 ...
