Installing the Carrier Assembly
on a Wall
■
■
Install high on wall, leaving at least 1 ½ feet (45.7 cm) between
antenna and ceiling
See “Key Components” earlier in this booklet for additional
picture detail
Check to make sure the carrier
1
assembly’s power cord is
unplugged from the wall outlet before
continuing.
Place the carrier assembly against
2
the wall. Choose a location
backed by a wooden stud (if unavailable,
use toggle bolts instead of the supplied
wood screws). Hold the carrier assembly
straight; use a level if needed. Using a
nail or pencil, mark screw locations
through the four wall mount holes.
Start screws, leaving the screw heads
approximately ½" (12 mm) from the wall.
Place the carrier assembly over the
screws, then slide it downward to lock it
into place. Tighten the screws.
Remove the plastic cap
3
covering each radio module’s
card edge before installing the radio
modules in the carrier assembly.
16
