Testing Your System
Digital Life User Manual
|
Page
56
of
62
ATT-UM-V1.1-201303
Device
Procedure
Results
Notes
observed, enter your
Alarm Panel PIN to
cancel the alarm and
then enter your Alarm
Panel PIN again to clear
the message
unit replaced
•
Four (4) to Seven (7)
flashes: Unit is within
normal sensitivity range.
No action is required.
•
Eight (8) or Nine (9)
flashes: Have unit
replaced
Glass
Breakage
Sensor
(SW-ATT-GB)
•
DLS in Test Mode
End-to-End Testing
•
Test each device one at
a time by executing the
following procedures
o
Arm the system in the
Armed-STAY Mode
o
Push and hold the
test button for five (5)
seconds and release.
The red LED will
illuminate while the
button is pressed.
o
The green LED will
blink twice to indicate
that the unit is in the
RF test mode for 90
seconds
o
After alarm has been
observed, enter your
Alarm Panel PIN to
cancel the alarm and
then enter your
Alarm Panel PIN
again to clear the
message
End-to-End Testing
•
For each device
•
Keypad LCD will display:
< Device Name> - Glass
Breakage (For example,
“Dining Room - Glass
Breakage”)
•
Keypad LCD will display:
Intrusion Alarm Sent
•
Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
•
Keypad LCD will display:
Alarm Canceled
•
Keypad LCD will display:
Enter PIN to Clear
Functional Testing
•
Keypad LCD will display:
< Device Name> - Glass
Breakage (For example,
“Dining Room - Glass
Breakage”)
•
Keypad LCD will display:
Intrusion Alarm Sent
•
Keypad LCD will
•
An Intrusion alarm
has been sent to
AT&T Digital Life
Central Monitoring
Center with no
action required
•
Must use a glass
break simulator,
such as the
Intellisense Model
FG-701.