Carbon Monoxide Detector Features and
Operation
Digital Life User Manual
|
Page
32
of
62
ATT-UM-V1.1-201303
Carbon Monoxide Detector (SW-ATT-CO) Operation
The Carbon Monoxide Detector (SW-ATT-CO) detects carbon monoxide only. It does
NOT detect fire, smoke, or any other gas. It gives early warning when potentially
dangerous levels of carbon monoxide exists by turning on the
red
light
indicator and
sounding four (4) short beeps then silence repeating. An alarm signal is transmitted to
the DLC-100 within 15 seconds of detecting a dangerous concentration of carbon
monoxide.
NOTE:
The alarm automatically resets when carbon monoxide is no longer detected.
The following are some operational characteristics of the Carbon Monoxide Detector
(SW-ATT-CO):
Operation
Status
LIGHT
Display
Alarm
Sound
Units Status
Recommendation
Normal
operation
Green
Power
LIGHT
flashes
every 30
seconds.
None. Normal
operation
with good
batteries. Not
sensing any CO.
None.
Carbon
Monoxide
alarm
Red Alarm
LIGHT
flashes with
beeps.
Four quick
beeps, 5
seconds
silence,
repeating.
Alarm condition.
Dangerous
concentrations of
CO detected.
Low
battery/
low
battery
hush
Red Alarm
LIGHT
flashes
every 60
seconds.
One quick
beep every 60
seconds.
Batteries need to
be replaced.
Replace all three AA
batteries.
Press Test/Hush button
and release. This will
silence the low battery
audible chirp between 8
and 11 hours allowing for
a more convenient time to
replace the batteries.
Alarm
end-of-life
indicator
Red Alarm
LIGHT
flashes two
times every
30 seconds.
Two quick
beeps every
30 seconds.
End of CO Alarm
life.
Press the Test/Hush
button and release. This
will silence the end-of-life
signal for up to three days.
After three days, the unit
will resume end-of-life
chirps. Hush mode will
silence the alarm ten times
or up to 30 days. After 30
days, the unit can no
longer be hushed. Replace
the CO Alarm immediately.
The unit will not respond to
CO.