Testing Your System
Digital Life User Manual
|
Page
55
of
62
ATT-UM-V1.1-201303
Device
Procedure
Results
Notes
CO Detector
o
After alarms have
been observed,
enter your Alarm
Panel PIN to cancel
the alarms and then
enter your Alarm
Panel PIN again to
clear the message
Smoke
Detector
(SW-ATT-
SMK)
•
DLS in Test Mode
End-to-End Testing
•
Test each device one at
a time by executing the
following procedures
•
Press the
TEST/SILENCE button
for ten (10) seconds
•
After alarm has been
observed, enter your
Alarm Panel PIN to
cancel the alarm and
then enter your Alarm
Panel PIN again to clear
the message
Local Sensitivity Test
•
Press the
TEST/SILENCE button
for four (4) seconds
•
Once the test starts, the
smoke alarm LED
flashes one (1) to nine
(9) times
•
Count the number of
flashes
•
After alarms have been
End-to-End Testing
•
For each device
•
When smoke is
detected a loud
temporal 3 local alarm
is sounded
•
Keypad LCD will display:
<Smoke Device Name> -
Smoke Detected (For
example, “Master
Bedroom – Smoke
Detected”)
•
Keypad LCD will display:
Fire Alarm Sent
•
Keypad LCD will
Display: Alarm –
Enter PIN to Cancel
•
Keypad LCD will
display: Alarm
Canceled
•
Keypad LCD will display:
Enter PIN to Clear
Local Sensitivity Test
•
Zero (0) to Three (3)
flashes indicates: Have
•
A Fire alarm has
been sent to AT&T
Digital Life Central
Monitoring Center
with no action
required