3.
4.
5.
6.
Align the cover’s grooves with the unit’s front and back plates.
Push down on the cover until it is securely in place.
Turn the CAS upside down and insert the screws, that you previously set
aside, into the four screw holes. Tighten the screws.
Turn the CAS right side up. Plug its power supply into a 3-prong ac power
outlet.
Testing Procedures
Now that your CAS is installed, you need to test it to make sure that it is
operating properly. The following tests will help you determine if you have
installed your CAS correctly. If these tests reveal any problems, refer to the
section titled "Troubleshooting Tables."
SYSTEM DIAGNOSTICS MESSAGE
The system diagnostics message contains information that will help you
verify system options that you may have set. To generate a system
diagnostics message (Figure 14), follow the instructions below.
053084.201834
212516.609213
F0ATT0.F8ATT0
E0ATT0.E8ATT0
00.00 00.50 00.00 00.50 00.00 00.00
00 0.0 00 19
D D D D D
60 08 00 17 40 23 60
Figure 14
Example of a System Diagnostics Message
1. Make sure that your printer has been installed and is properly function-
ing according to its manufacturer’s instructions. Refer to the manual sup-
plied with your printer.
2. Make sure that the printer's ac power cord is plugged in and that its power
switch is set to the on position. If your printer has a ready button, make
sure it is on.
3. Remove and reinsert the cartridge into the CAS's catridge slot. The red
light labeled Ready goes off and then on. A system diagnostics message
is printed.
4. Verify each system option that you may have set (Figure 14).
If a system diagnostics message is not printed, refer to the section titled
“Troubleshooting Tables.”
15
