123
122
INSTALLATION GUIDE
Electrical connection
For the connection, use an approved cable, in accordance with the
regulations.
The cable casing should be of rubber.
There is a label on the underside of the appliance with the wiring
diagrams. The connection terminals are accessible once you have opened
the junction box on the underneath. The junction box cover can be
opened with a screwdriver.
If you want to make a fixed connection, make sure that a multi-polar
switch with a contact separation of at least 3 mm is fitted in the supply
line.
Power setting table
Type of hob
HL60..G
HL60..M
HL70..M
Cooklight
x
x
x
Electrical connection
230 V - 50 Hz
x
x
x
Power of element
Front left double
2200/1000 W
2200/1000 W
2200/1000 W
Rear left
1200 W
1200 W
1200 W
Rear right
2000 W
Rear right double
1700/700 W
Front right fish pan
2200/1400 W
Front right
1200 W
1200 W
2000 W
electrical connection
INSTALLATION GUIDE
This appliance meets all relevant CE guidelines.
The data plate on the underside of the appliance indicates the total
nominal load, the required voltage and the frequency.
Safety
This appliance should only be connected up by a registered electrical
installer!
The electrical connection must comply with national and local
regulations.
The appliance should always be earthed.
Damage caused by incorrect connection, incorrect use or incorrect
building in is not covered by the guarantee.
For correct operation of the appliance it is important that:
–
the power cable hangs freely and is not struck by a drawer;
–
the worktop is level.
The walls and the worktop around the appliance must be made of heat-
resistant (>85°C) material. Even if the appliance itself does not get hot,
the heat from a hot frying pan, for instance, could cause discolouring or
damage to the wall or worktop.
general
