To receive firmware updates for the cooking hob, you need to
be paired to the cooking hob via the mobile app. You will receive
a notification, or you can check available firmware updates on
the mobile app menu for updates.
FoA
- Firmware update over the
air
In order to start the firmware update via the mobile app, set this
setting to on to confirm your presence at the cooking hob. For
more information see chapter Firmware Update. After 10 min,
this setting is automatically reset to off.
In demo the appliance will act as usual, without the possibility
to heat the cookware.
dE
- Demo Mode
(Demo Mode for Dealer
Showrooms)
When set this will be indicated after switching on the appliance
with a short "d" indication;
Without any user interaction the appliance will automatically
switch off after 10 minutes.
If your electrical wiring or circuit breakers do not meet the
specified current draw on the rating plate, the current limiter can
be activated by reducing the value of this setting. Doing so may
cause a reduced performance of the induction hob.
Con
- connection power
Current limiter
NOTE!
To prevent unintentional
adjustment of the 'CON -
connected power', CON
setting must be confirmed
when changed by touching the
slider for 3 seconds. A change
without confirmation will not be
implemented!
The following numbering format of the setting is available: X.XX.
The number left of the dot represents the number of connected
phases, while the number right of the dot represents the
electrical current per phase in Ampere.
WARNING!
The appliance must always be set to the actual or lower rating
of the electrical wiring or circuit breakers. This setting can
only be set by an authorised expert.
38
Settings
