Atag HG6411WEBA/A01, Инструкции по преобразованию

Страница: 17 / 32

EN 5
CONVERSION INSTRUCTIONS
Contents of the conversion set:
• Injector for the wok burner head and wok burner distributor (see
Figure A1 at the back of these instructions);
• Simmer adjustment screw for the wok gas tap;
• Gaskets;
• Fibre rings for enamelled appliances.
Disassembly (B)
Note: disconnect the appliance from the power supply before removing
the drip tray! Avoid damage to the worktop by laying the parts of the
appliance on a protective surface.
1. Remove the pan supports, burner heads and burner distributors.
Pull the control knobs upwards and remove them.
2. Dispose of the wok burner distributor and wok burner heads (Figure
B4).
3. Loosen the screws of the mounting brackets under the appliance
(see Figure B1 at the back of these instructions).
4. Remove the screws around the burners (see Figure B2 at the back
of these instructions).
5. Lift the back of the drip tray and slide the tray forwards. When an
earth lead is connected to the drip tray, disconnect the lead (see
Figure B3 at the back of these instructions).
6. Remove the drip tray.
Conversion (C)
The position and the type of burner (capital letter) and tap (small letter)
are shown on the label inside the bottom tray.
Note: only applicable to appliances connected to G20/20 mbar or G25/
G25.3 25 mbar gas supplies (see Table 1).
The burner assembly can consist of one of the following sets:
• Sets ‘H2’ and ‘h’ for the wok burner.