Atag HG6411WEBA/A01, Инструкции по преобразованию, Страница: 18 / 32

EN 6
CONVERSION INSTRUCTIONS
1. Replace simmer adjustment screw ‘h’ in the gas tap.
Use a 4 mm flat-head screwdriver and, if necessary, pliers to
remove the simmer adjustment screw (see Figure C2 at the back of
these instructions) and then fit and tighten the new screw.
2. Replace the wok burner’s inner burner injector (H2) using a 7 mm
open-ended spanner.
Note! The inner burner's injector is the top injector in the burner
body (see Figure C1 at the back of these instructions).
Leak test and performance check (D)
When the appliance is connected to the gas supply: carry out the
leak test using the leak-test spray.
1. Seal the injector.
2. Open the gas tap.
Note: taps fitted with a thermal safeguard must be pressed in, turned
open and kept pressed in!
3. Spray the leak-test spray on the connections and inspect for leaks.
4. Repeat for each burner.
When the appliance is not connected to the gas supply: carry out
the leak test under pressure using an air pump.
1. Connect the pump to the gas pipe and close all gas taps.
2. Increase the pressure to 150 mbar and close the valve between the
pump and pressure gauge. Check the pressure. The pressure may
not fall by more than 5 mbar a minute. After the test, open the valve
between the pump and pressure gauge.
Note: taps fitted with a thermal safeguard must be pressed in, turned
open and kept pressed in!
3. Increase the pressure to 150 mbar and once again close the valve
between the pump and pressure gauge. Check the pressure. The
pressure may not fall by more than 5 mbar a minute.
4. Repeat this test for all taps and injectors.