The appliance’s packaging is recyclable. The following can be
used:
• cardboard;
• polyethylene film (PE);
• CFC-free polystyrene (PS rigid foam).
Dispose of these materials in a responsible way and in
accordance with government regulations.
The authorities can provide you with information about how
to dispose of discarded domestic appliances in a responsible
way.
GB 11
environmental aspects
disposal of packaging and appliance
GB 10
faults
what should I do if…
If the appliance does not work properly, it does not always mean that it is defective. Try
to deal with the problem yourself first. Phone the service department if the advice given
below does not help.
fault
Burner does not burn or
does not burn correct
ly.
The burner does not light.
Burner lights but goes out
again.
The warming zone has been
switched off and the indicator
flashes.
cause
No gas.
Burner is dirty or damp.
Burner cap not fitted on the
burner correctly.
The ventilation slots at the
rear of the appliance are
blocked.
Appliance is not suitable for
the type of gas used.
Sparking plug dirty.
Burner dirty or damp.
Burner cap not fitted on the
burner correctly.
Incorrect gas/air mixture.
Burner protection not
working.
The warming zone switches
off automatically after two
hours.
There is an object on top of
the touch control.
solution
Open the gas tap.
Clean and/or dry the burner.
Fit the burner cap on the
burner correctly. Bear in mind
the position of the lugs.
Unblock the ventilation slots.
Check the data plate and in
the case of discrepancies
warn the authorised installer.
Clean the sparking plug.
Clean and/or dry the burner.
Fit the burner cap on the
burner correctly. Bear in mind
the position of the lugs.
Turn gas tap slightly.
Hold control knob pushed in
fully for longer.
Press the touch control for
one second until the red
indicator light goes out.
Remove the object from the
touch control. Press the
touch control for one second
until the red indicator light
goes out.
